The PHONO preamp will unleash tremendous dynamics and resolution to your listening experience.
- Optimized two stage architecture
- Low noise 40dB input stage
- Custom discrete output stage with adjustable gain
- Precision RIAA network
- High drive output buffer
- Low noise multi-stage channel independent power supply
- Ground optimized PCB layout
DSSA, Discreet Single Stage Amplifier
This is a very fast, low noise amplifier with a single-stage folded cascode architecture and over 500mA of peak current output capability. It maintains very low constant distortion levels through the audio band because of its high open-loop bandwidth. The DSSA module brings a further element of dynamic resolution and contrast to the e.One Phono. The vertical modular design permits a tight, efficient Printed Circuit Board (PCB) layout that combines the best of IC based and discrete component design.
Gain and Resistance Customization
The PHONO can work with a wide variety of cartridges by adjusting the dip switches for gain and resistance on the back of the unit.
||20Hz-20KHz +/- 0.2 dB
|Signal to Noise Ratio 40 dB gain:
||>80 dB A weighted, re 5mV RMS in
|Distortion @ 2 Volt RMS/1KHz:
||Adjustable 31 to 47k (View dip switch alignment)
|Gain Level Options:
||Adjustable 38dB to 60dB (View dip switch alignment)
|Power On usage:
|Power Off usage:
|Internally Set Operating Voltages:
||100-120VAC or 230-240VAC 50/60 Hz
||8.5 x 3.5 x 12?, 216 x 88 x 305mm (W x H x D)
Features and specifications are subject to improvements and changes without prior notice.